The Power Switch can be used to control a Switch device whose state can be determined (myStrom Switch, openHAB Thing/Switch, Philips Hue, FRITZ!Device). See also chapter MyStrom Integration for more information.

Control Attribute

Button If this option is disbled, default buttons will be used (red, green and grey bullet)
Bitmap On Image which will be displayed if the power switch is tunred on.
Bitmap Off Image which will be displayed if the power switch is tunred on.
Bitmap Wait Immage that will be displayed if the state of the power switch could not been determined yet.
ID Optional attribute. Is is used for some special configurations only.

Layout Attribute

The Layout Attributes of a control are described in chapter Control Layout.

Actions

You can define actions for the following triggers:

On Will be executed when clicking on the button (turn on)
Off Will be executed when clicking on the button (turn off)
State Determines the state of the Switch device and should be linked in any case directly to the Command „state“. It must have only one Action with trigger „state“.
onstart will be executed while creating the page after the control is initialized

You can read more about actions in the chapter Actions.

Events

In chapter Events, you can read more about events.